Ans: The insulating additive will help keep the deck cooler while providing a slightly slip resistant surface.

Answer: The insulating additive will help keep the deck cooler while providing a slightly slip resistant surface.

Ans: Complete instructions are included with every order. The ceramics are a very fine powder and blend into paint quite easily with a simple stirring using a paint paddle. The addition of ceramics to your paint will thicken it slightly and you may have to add a little water ( up to 1 pint ) to bring the paint back to a useable consistency. We recommend thinning with our Acriflow, the latex paint reducer/enhancer that turns any paint into a "Super Paint".

Answer: Complete instructions are included with every order. The ceramics are a very fine powder and blend into paint quite easily with a simple stirring using a paint paddle. The addition of ceramics to your paint will thicken it slightly and you may have to add a little water ( up to 1 pint ) to bring the paint back to a useable consistency. We recommend thinning with our Acriflow, the latex paint reducer/enhancer that turns any paint into a "Premium Paint".

You should certainly protect your deck from unnecessary moisture intrusion and the harmful effects of the sun's ultra-violet rays. Use of a penetrating stain, containing water repellant ingredients in most cases will protect your deck best. The pigment in the stain will absorb the ultra-violet rays from the sun and protect the wood fibers from degradation. In most cases a stain will need maintenance every 2-4 years while clear sealers require maintenance every 1-2 years.

When you're looking for a painted-kind-of-look to match you home exterior, or when the deck has been totally neglected, solid stains hide and conceal any cosmetic imperfections that the lumber may have.

Answer: Packages are pre measured for 1 Gal, 2 Gal and 5 Gallons of paint. Money saving bulk packaging is available also. You can figure on an average coverage rate of 250-300 sq. ft. per gallon for most house paints on smooth surfaces.

Ans: Packages are pre measured for 1 Gal, 2 Gal and 5 Gallons of paint. Money saving bulk packaging is available also. You can figure on an average coverage rate of 250-300 sq. ft. per gallon for most house paints on smooth surfaces.

Even though the lumber may be kiln-dried before treatment, using water-borne preservatives restores moisture to the wood. Too much moisture in the wood may prevent the stain or paint from penetrating the wood sufficiently. It is best to test the wood by painting or staining a scrap piece to see if it applies properly. If not, wait until it does. A water repellent should be applied annually. Do not use latex paints. Semi-transparent, oil-based stains work best.

Peeling is generally a sign of a lot of excess film on the surface and not enough penetration. This could be due to surface contamination, high moisture content in the wood, a previous stain not allowing the new stain to penetrate, or a wet on dry application instead of wet on wet.

Creative Wood Products has their own private label stain called Deck Gold. Deck Gold is an oil based semi-transparent sealer and stain in one. It is a unique blend of resin, pigment oil, mildewcide and UV protectors that penetrate deeply into the wood to protect and preserve it. Deck Gold can be used on all types of wood except Redwood. We also carry Superdeck Products, Superdeck is a natural oil, transparent stain designed to maintain the beauty of your wood.

Most clients prefer to stain the house. These are available in many shades and hues and are available widely. There are UV repellant brands which make it possible to prevent fading over time. However should you decide to use paint any oil based paint is satisfactory.

No. Nearly all stains contain a waterproofing additive, which is just as effective as that used in waterproofing sealers. Often, application of a waterproofer over a stain is counterproductive because the surface is no longer porous enough to accept the waterproofer.

The product does not require traditional timber treatments or any other kind of treatment BUT it will of course require normal cleaning with a pressure washer or hose/brush with a weak bleach solution or proprietary deck cleaning product to remove surface debris.

Conventional floor coatings will not acquire sufficient adhesion to a ceramic tile floor. A professional contractor could be called in to completely scarify the surface. Once the ceramic finish is completely removed, it may be possible to treat the surface as a masonry or concrete surface.

I prefer to use a large brush or a mop. You want to get large amounts of Stain Solver liquid on the deck surface. Hand pump sprayers often apply too little solution to the surface. If you must use a sprayer, make sure the product has dissolved completely or you will clog the nozzle! Also, be sure you spray on lots of liquid.

Northgate Garage Doors, Inc., does not specifically recommend one particular kind of paint, stain, or varnish over another. But, it seems Watco™ oil and Behr™ spar varnish have become popular brands that many people use with excellent results. Watco and Behr™ products can be found at most home improvements stores.

Answer: It should not be used inside, the residue is to difficult to remove without rinsing, we recommend only using it outside

The available historical evidence shows that Eichler used stains, not paint, on his homes, inside and out. One can speculate that, at least for the vertical-grooved siding, stains were employed so that the grooves stayed crisp and clean (the edges weren't softened by the paint), and some of the grain of the wood showed through (redwood siding was used throughout the 1950s). It is also possible that Eichler used stains because labor and materials costs were lower than for paint.

We do offer "certain styles of pre-primed balusters" but we do not do any painting or staining of any kind.

Jennings joinery prefers to paint or stain prior to glazing and assembly to properly seal the product. Also when using 6.38 Laminated glass (which is thicker than normal glass), if the inside rebate is not painted or stained prior to glazing then after the product is glazed the unsealed surface behind the glass edge is visible and un protected. Also after the bi-folds have been installed it is very difficult to coat the top and bottom of the doors to seal then correctly.

Of course you can! But you need to take appropriate cautions. You probably don't want to use a ceramic cooker on a wooden deck with the just three ceramic feet that come, for example, with a Big Green Egg. While this does provide an air gap between the bottom of the cooker and the wood of the deck, you still need to be concerned with the odd ember or two that might come out of the lower vent.

You need to ask your supplier of the UV material you are trying to cure. Ask them if additional UV energy in the 390nm or 420nm range will provide any benefit.

In order to achieve the beautiful finish you want, you need to begin with a clean, dry surface. Flood's StainStrip? Exterior Stain Stripper can be used to remove even the most stubborn coatings like acrylic or oil-based solid color or semi-transparent stains.

Aesthetics: Clearly the outside of your home is a great source of pride. Having a manicured lawn and beautiful, clean deck allow for a great outdoor living experience. Entertaining, cook outs with family and friends on clean, protected surfaces create joyful memories that last for years to come. The best way you can protect your deck is power wash cleaning and professionally applied protection products.

All of our products are high end. Certain products will do better then others depending on your particular environment or type of wood that you have. If you came to our store looking for a certain brand name then we would suggest sticking with that. Please email us if you have any questions and we will be more then happy to suggest a certain brand depending on your situation.

That's an opinion call, but if you do, you will have to do it again every year. We recommend letting it grey naturally and washing it 2 or 3 times/year with Sunlight dishwashing soap to keep it clean and pollution-free.

I have a Westerbeke/Universal engine/generator and need to know the correct amount of oil for my unit and the recommended oil change intervals.